Adirondack Forum  
Rules Membership Donations and Online Store Adkhighpeaks Foundation ADKhighpeaks Forums ADKhighpeaks Wiki Disclaimer

Go Back   Adirondack Forum > The Adirondack Forum > Hunting and Fishing in the Adirondacks
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
Old 02-14-2021, 07:20 PM   #1
pierce1308
Member
 
Join Date: Sep 2014
Posts: 8
Salmon and lake trout trolling spoons

I haven't had much luck so far trolling in the adirondacks for lake trout and salmon on the smallest mooslook wobbler spoons, wd dreamweaver , and scorpion Michigan stinger spoons .... I was wondering what works better for everyone else for spoon brands and sizes ?would the bigger size large or junior spoons specificaly for mooslook wobblers work than the smaller size I'm using? Also does the copper or gold blanks do better in the tea stained water than Nickel silver blanks ? I mainly fish lake placid, tupper lake , upper saranac lake, Taylor pond , lake george and raquatte lake
pierce1308 is offline   Reply With Quote
Old 02-15-2021, 10:11 AM   #2
adkman12986
Member
 
adkman12986's Avatar
 
Join Date: May 2008
Location: Tupper Lake
Posts: 864
44 Sutton and lead core Slow drift and jerking the spoon
adkman12986 is offline   Reply With Quote
Old 02-17-2021, 03:31 PM   #3
JimVroman
Member
 
Join Date: Mar 2015
Posts: 122
Minnow imitating lures like Rapala are also good for each of these fish.
JimVroman is offline   Reply With Quote
Old 02-18-2021, 09:07 AM   #4
St.Regis
Member
 
Join Date: Feb 2007
Posts: 1,447
I'd have a couple Lake Clear wabblers in the box too. Put a smelt imitator behind it and slow troll over deep water between points and islands. I've never pulled one using lead core, but I don't see why that wouldn't work. Good luck!
St.Regis is offline   Reply With Quote
Old 02-21-2021, 12:58 PM   #5
EagleCrag
Member
 
EagleCrag's Avatar
 
Join Date: Mar 2010
Location: Gloversville, NY
Posts: 1,252
I use silver spoons about 3 1/2 to 4" long and about 3/4 inch wide at the widest point. I usually stick to silver to imitate smelt, which is usually the predominant forage fish. Will switch colors if not having luck. I fish the spoons off a 3 way and bounce the sinker off the bottom. Or raise it up if I mark fish up in the water column. Lightweight flutter spoons are best IMO. The Crossroads deli and bait shop is just off one of the Northway exits near Chestertown (not sure which one) and they have a good selection of spoons. I have also had good luck with soft baits with paddle tails, again about smelt size and color. I'd send pics but I'm in California at present and not near my tackle. My most successful lure is a jig though, 3/8 to 1/2 oz tied with bucktail and quite a bit of flash on the sides. I tie them mostly white with either a black or dark blue top on them, again to imitate smelt. Putting some scent on them seems to help some too. I don't vertical jig with them but cast them far behind the boat and jig the rod as I troll along. Good luck.
EagleCrag is offline   Reply With Quote
Old 02-22-2021, 11:36 AM   #6
Lucky13
Member
 
Join Date: May 2018
Posts: 628
I am also partial to a Sutton 44, which fits EagleCrag's specs pretty well, mostly in silver. I've also done well on both species with Fluorescent Orange Mooselicks. If I am targeting Lakers, I'm bouncing bottom, but for Landlocks I stay way up in the water column, and I troll fast. This is getting harder to do now that I am relying on oar power, but most of my hits come when I've got the boat moving pretty good. When I used to run a motor, I would sometimes get them in the prop wash, and the boat would be well above the idle speed I use for Lake trout.
Lucky13 is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:14 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.

DISCLAIMER: Use of these forums, and information found herein, is at your own risk. Use of this site by members and non-members alike is only granted by the adkhighpeak.com administration provided the terms and conditions found in the FULL DISCLAIMER have been read. Continued use of this site implies that you have read, understood and agree to the terms and conditions of this site. Any questions can be directed to the Administrator of this site.